Resources › Tanks & Systems
Fuel Storage for Mine Sites: Comparing Tank Options for Safety and Compliance
A mine runs on diesel, often a long way from the nearest supplier. The storage has to hold enough, contain what it holds, and tell someone off site what is left.
- Capacity
- Containment
- Monitoring
- New Sites
When comparing diesel storage for a mine site, look at five things. Capacity, measured against daily use and the time between deliveries, with a margin for a late truck. Containment, where self-bunded tanks hold a leak inside a second skin instead of relying on a separate bund. Relocatability, because a tank built to shipping container dimensions can move with the pit or to the next project. Monitoring, so tank levels and every litre dispensed can be seen without someone driving out to dip the tank. And dispensing, matched to the machines that fill from it, with AdBlue alongside where the fleet needs it. Mine site storage sits under AS 1940, the work health and safety laws for mines in that state or territory, environmental requirements and the operator's own site standards, so confirm what applies before choosing the size and the location.
Fuel is one of the largest running costs on a mine and one of the few that can stop production outright. Haul trucks, loaders, dozers, drills, light vehicles and generators all draw from the same supply, and on a remote site the next delivery may be days away. Storage that is too small, poorly placed or not watched closely turns a delivery delay into idle plant.
This guide is for mining and procurement managers comparing options for an operating mine or planning refuelling for a new one. A-FLO's construction site fuel storage article covers civil projects, where the questions are similar but the timescales are shorter.
123,500 L The largest listed Fueltainer self-bunded diesel tank, the FT123
110% Integrated spill containment on Fueltainer, Fuelbox and Fuelcube self-bunded tanks
Remote Tank levels reported over GSM or LoRa, with solar or battery power for tanks away from mains
What to Compare When Choosing Mine Site Fuel Storage
Tank options for mining are easier to compare once the site's own numbers are on the table. These are the points that separate one option from another.
| What to compare |
Why it matters on a mine site |
| Usable capacity |
Daily use multiplied by the days between deliveries, plus a reserve for a late or cancelled delivery and the volume below the pump suction |
| Containment |
A self-bunded tank holds a leak inside its outer skin. A single-skin tank needs a separately built bund that has to be designed, built and kept clear of water |
| Relocatability |
Pits move and projects end. A tank built to shipping container dimensions can be lifted, transported and set down again when it is empty |
| Dispensing |
Flow rate and the number of hoses, sized for the largest machines and the number filling at shift change |
| AdBlue |
Newer haul trucks and light vehicles may need AdBlue. A combination tank keeps both fluids at one refuelling point, in separate compartments |
| Monitoring and control |
Remote tank levels for delivery scheduling, and a fuel management system recording every litre by machine and operator |
| Refill logistics |
Road train access to the fill point, the size of a full delivery, and whether the tank has room to take it |
Self-Bunded Tank Options for Mining
Most new mine site storage is self-bunded. The tank is double walled, the outer wall holds 110% of the inner tank, and pumps, filters and meters sit in a lockable cabinet built onto the tank. A-FLO's range covers the scale of a mine from the main refuelling point to a remote pump station.
| Option |
Listed capacity |
Where it fits on a mine |
| Fueltainer |
From 11,240 litres to the 123,500 litre FT123 |
The main refuelling point. Built to shipping container dimensions, with 10 micron filtration and compatibility with A-FLO's BSmart, Fluidlink and Fluidtrack fuel management systems |
| Fueltainer diesel and AdBlue combination |
For example the FT23/4.5 |
A single refuelling point for diesel and AdBlue, in separate compartments, with dedicated dispensing for each fluid |
| Fuelbox |
5,000 to 20,000 litres |
Workshops, light vehicle fuel bays and smaller pits. An enclosed, lockable pump bay keeps the dispensing equipment out of the dust and weather |
| Fuelcube |
From 1,000 to 10,000 litres |
Generators, camps, exploration sites and pump stations where the volumes are small |
| Fuel trailers |
Single skin or self-bunded |
Taking fuel to tracked plant and machines that cannot easily travel to the bowser. ADR compliant for road registration |
Capacities above are from A-FLO's current listings. Self-bunded fuel and diesel tanks explains the construction in more detail, and A-FLO's guide to choosing the right size and type of tank covers sizing from first principles.
One large tank or several smaller ones
A single large tank is simpler to fill and to monitor. Two or more smaller tanks keep fuel available while one is being cleaned, repaired or moved, and let refuelling points sit closer to where the machines work. Many sites end up with a main tank near the workshop and smaller tanks or a trailer serving the pit.
Safety and Compliance on a Mine Site
Diesel is a combustible liquid, and its storage is addressed in Australia by AS 1940. On a mine, that sits alongside the work health and safety laws for mines in the state or territory, environmental requirements, and the mine operator's own site standards and approval process for new plant. Which requirements apply depends on the quantity stored, the tank, the location and the jurisdiction.
- Containment. A self-bunded tank provides its own secondary containment. A single-skin tank needs a bund that meets the requirements for the site.
- Location. Keep tanks away from ignition sources, traffic routes and drainage lines, and give delivery tankers a safe approach and room to turn.
- Access. Ladders, platforms and guardrails for anyone who has to climb onto the tank. Fuelbox tanks are listed as compliant with AS 1940, AS 1692 and AS 1657, the standard for fixed platforms, walkways, stairways and ladders.
- Signage and records. Dangerous goods and combustible liquid signage, a spill kit at the refuelling point, and records of deliveries, inspections and maintenance.
- Vehicle interaction. Bollards or barriers between the tank and heavy vehicles, and a clear rule for where machines stop to refuel.
This article does not state quantity thresholds, separation distances or bunding specifications, because they depend on the site and the jurisdiction. A-FLO's plain English guide to AS 1940, EPA and council approvals and the overview of Australian standards for diesel tanks are the place to start, alongside the mine's own approval process.
Setting Up Refuelling on a New Mine Site
On a new mine, refuelling is usually needed before the permanent infrastructure is built. These steps are the usual order of work.
Forecast the fuel demand
List the plant for each stage of the mine plan with its expected hours, and estimate daily use from the manufacturers' figures or the fleet's records. Demand usually rises as the fleet arrives, so plan for the peak, not the first month.
Confirm supply and delivery terms
Agree with the fuel supplier how often they will deliver, how much a delivery holds and how much notice they need. The tank has to take a full delivery with room to spare, and hold enough to cover the gap if a truck is late.
Choose the location
Near enough to the work to keep machine travel short, on firm level ground, clear of drainage and haul roads, with safe tanker access. On a site that will change shape, choose a location that will not be mined through.
Select the tanks and dispensing
Match capacity, hoses and flow rate to the fleet, add AdBlue where the machines need it, and decide whether a trailer will serve plant that cannot come to the tank.
Specify monitoring and control from day one
Fit tank level monitoring and a fuel management system at installation. Adding them later means a period with no record of where the fuel went.
Install, commission and train
Set the tank on a prepared base, connect power or solar, commission the pumps, meters and alarms, and train the operators who will refuel and the people who will read the reports.
Monitoring and Control at a Remote Site
On a remote mine, the question of how much fuel is left is usually answered too late. Two systems answer it continuously.
Levels
Automatic tank gauging
LEVELTRACK and FLUIDLEV gauges report the level remotely over GSM or LoRa, with mains, solar or battery power, so deliveries are ordered on a schedule rather than in a hurry.
Access and records
Fuel management
A fuel management system releases fuel only to authorised operators and machines, by key fob, RFID card, PIN or vehicle tag, and records every transaction.
Quality
Clean fuel
Dust and water are hard to keep out on a mine. Filtration on the outlet protects injectors, and fuel filtration explained covers what the ratings mean.
Together, metered dispensing and a continuous level record make reconciliation possible: litres delivered, minus litres dispensed, should match the change in the tank. A-FLO's fuel management systems buyer's guide covers how to choose a system, from one refuelling point to a network of sites. For keeping stored fuel in condition, see water in diesel and how long you can store diesel.
Hire or Buy for Mining Procurement
Whether to hire or buy storage usually comes down to how long the site will need it and how sure the plan is.
- Buying tends to suit an operating mine with a long life, where the tanks will stay in service for years and can be fitted out exactly to the site.
- Hiring can suit a short project, an exploration program or the early months of a new mine, before demand is known.
- Either way, compare the same things. Containment, monitoring, compliance documentation, who maintains the equipment and who moves it at the end.
Spill prevention is part of the same decision. A self-bunded tank, an overfill alarm, a spill kit at the refuelling point and metered dispensing all reduce the chance of diesel reaching the ground, and the records a fuel management system keeps show where fuel was used.
Beyond Diesel: Lubricants, Coolant and Waste Oil
A mine workshop needs bulk storage for more than fuel. A-FLO delivered a five compartment self-bunded tank with a combined capacity of more than 107,000 litres for Castrol at the Cataby mine, for lubricants, coolant and waste oil, with automatic tank gauging on every compartment. At the Mt Pleasant mine, A-FLO designed and installed a lubricant storage tank farm for MACH Energy that stores and distributes 11 lubricants. A-FLO's bulk new oil and waste oil tanks cover the same need on a smaller scale.
What Goes Wrong
- Sizing for the average day. The tank runs low at the peak, or when a delivery is late.
- Putting the tank where it is convenient today. The pit moves, and the tank ends up in the way or too far from the work.
- Adding monitoring later. Months of fuel go unrecorded, and losses cannot be traced.
- No room for a full delivery. The tanker leaves part full, and the site pays for a delivery it could not take.
- Ignoring water and dust. Breathers, filters and regular draining keep contamination out of the fuel and the engines.
- Treating the tank as the whole system. Dispensing, AdBlue, lubricants and waste oil all need a place in the plan.
Frequently Asked Questions
How can mining managers in Australia find effective and compliant diesel storage solutions?
Start with the site's numbers: daily fuel use, time between deliveries and how long the storage will be needed. Then compare tanks on capacity, containment, relocatability, dispensing and monitoring, and confirm the requirements that apply under AS 1940, the state or territory mining safety laws and the mine's own standards before choosing the size and location.
What are the best self-bunded tank options for the mining industry in Australia?
It depends on the volume and the job. Large Fueltainer tanks, from 11,240 litres to 123,500 litres, suit a main refuelling point and are built to shipping container dimensions so they can be moved. Diesel and AdBlue combination tanks put both fluids at one point. Fuelbox tanks from 5,000 to 20,000 litres suit workshops and smaller pits, and Fuelcube tanks suit generators, camps and exploration sites.
What should I consider when comparing fuel tank options for mining operations?
Usable capacity against daily use and delivery frequency, containment, whether the tank can be relocated, the flow rate and number of hoses, whether AdBlue is needed, remote level monitoring, fuel management, and tanker access for refilling.
How do you set up refuelling on a new mine site?
Forecast fuel demand from the mine plan, agree delivery terms with the supplier, choose a location with safe tanker access that will not be mined through, select tanks and dispensing to suit the fleet, fit monitoring and fuel management from the start, then install, commission and train the operators.
Should a mine hire or buy its fuel tanks?
Buying tends to suit a long-life operating mine. Hiring can suit a short project, exploration or the early months of a new mine before demand is known. Either way, compare containment, monitoring, compliance documentation, maintenance and who relocates the equipment.
How can a mine site reduce the risk of fuel spills?
Use self-bunded tanks that contain a leak inside an outer skin, fit overfill alarms, keep a spill kit at the refuelling point, protect tanks from vehicle impact, and meter every litre dispensed so losses show up in the records.
Can tank levels on a remote mine be monitored without visiting the tank?
Yes. Automatic tank gauging reports the level remotely over GSM or LoRa, and can run on solar or battery power where there is no mains supply. Deliveries can then be scheduled from the reported levels.